Summary: XP-SKX Series Shredder (SKX & XP-SKX) pumps leave solids slightly larger than if passed through a grinder pump. The shredding action is caused by using a cutting impeller with a Tungsten Carbide Tip, against a "spiral" shaped diffuser plate. XP-SKX -pumps have non-clog impellers designed for high volume and lift performance. All "wet" parts such as impeller, wear-plate and pump-housing are made of Cast 316 stainless material. The elastomers such as o-rings, lip seals and gaskets are made of FKM. Standard power cable is made of oil-resistant material. Special installation can be made with EPDM power-cable and elastomers. (BUNA (Nitril) also available). FM Approved motor for use in Class I, Division 1, Groups C & D hazardous locations. Available in 208, 230, 460 or 575 Volt 60Hz. Contact factory for 50Hz availability.
-
All parts exposed to pumped liquids are made of 316 Stainless Steel.
-
Three Seal Motor Protection - Motor is protected by two independent mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic. An additional lip seal has been installed to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber. Standard elastomers are Buna N (FKM optional).
-
More Motor Protection - Air filled motor with winding protection and (NEMA) Class F motor insulation. Seal leakage detector(s) in seal chamber offers early warning should water enter the chamber.
-
Epoxy Coated Motor Housing - Superior two part epoxy to protect the motor from exposure to the surrounding liquid.
-
Tough Pump Construction - Hardened cast iron stands up to rough handling and pumping sandy water unlike pumps with soft resin impellers or plastic exterior components.
-
Longer Power Cord - Standard 50ft. power.
Details:
GENERAL DATA | MAX. FLOW: GPM | 360 |
| MAX. HEAD: ft | 62' |
| DISCHARGE SIZE | 3" NPT-M |
| MAX. SUBMERGED DEPTH | 65' |
| SHIPPING WEIGHT:lbs | 178 |
CONSTRUCTION/MATERIAL DATA | MOTOR CASING | CAST IRON, EPOXY COATED |
| PUMP VOLUTE | 316 SS |
| STRAINER / STAND | 316 SS |
| LIP SEALS & O-RINGS | FKM |
| ROTOR SHAFT | 403 SS |
| EXTERNAL HARDWARE | 304 SS |
ELECTRICAL/MOTOR DATA | MOTOR RATING: HP | 5 |
| MOTOR RPM | 3450 |
| MOTOR INSULATION CLASS | F |
| MOTOR SERVICE FACTOR | 1.15 |
| VOLTAGE | 460 |
| CURRENT F.L.A. | 7.0 |
| MOTOR PROTECTION | TWO NORMALLY CLOSED THERMOSTATS |
| POWER CORD: GAGE; LENGTH | A.W.G. 14/4 50', SOOW |
| MAXIMUM LIQUID TEMPERATURE | 104° F |
