Summary: The Shredder (SK) pumps leave solids slightly larger than if passed through a grinder pump. The shredding action is caused by using a cutting impeller with a Tungsten Carbide Tip, against a "spiral" shaped diffuser plate.
NEW PRODUCT: Explosion Proof Shredder Pump! Need explosion proof pumps for use in Class 1, Division 1, Groups C & D Hazardous -
Longer Power Cord - Standard 33ft. power.
-
304SS Motor Housing - Superior abrasion resistance will not wear out like aluminum motor housings when pumping sandy water.
-
Three Seal Motor Protection - Motor is protected by double mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic. An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber.
-
More Motor Protection - Winding protection and (NEMA) Class F motor insulation allows motor temperature to raise to 230°F, superior to pumps with Class A and B insulation. Automatic switch turns pump motor off if temperature and/or amp draw raises too high. When the motor cools the switch will automatically reset and the pump will turn back on.
-
Tough Pump Construction - Hardened cast iron stands up to rough handling and pumping sandy water unlike pumps with soft resin impellers or plastic exterior components.
Details:
GENERAL DATA | MAX. FLOW: GPM | 360 |
| MAX. HEAD: ft | 62' |
| PUMP TYPE | Non Clog Shredder |
| DISCHARGE SIZE | 3" flange w/ 4" NPT-F discharge (3" NPT-M optional) |
| MAX. SUBMERGED DEPTH | 65' |
| MIN. SUBMERGED DEPTH | 15" |
| SHIPPING WEIGHT:lbs | 130 |
CONSTRUCTION/MATERIAL DATA | MOTOR CASING | 304 SS |
| PUMP VOLUTE | Cast Iron |
| STRAINER / STAND | Cast Iron |
| LIP SEALS & O-RINGS | Buna-N |
| ROTOR SHAFT | 304 SS |
| EXTERNAL HARDWARE | 304 SS |
| QTY. OIL IN SEAL CHAMBER | 11.8 U.S. FL. OZ. |
ELECTRICAL/MOTOR DATA | MOTOR RATING: HP | 5 |
| MOTOR RPM | 3450 |
| MOTOR INSULATION CLASS | F |
| MOTOR SERVICE FACTOR | 1.1 |
| VOLTAGE | 230, 3PH-60 Hz |
| CURRENT F.L.A. | 7 |
| MOTOR PROTECTION | Thermal & Amp Overload |
| POWER CORD: GAGE; LENGTH | A.W.G. 12/4; 33', STOW |
| MAXIMUM LIQUID TEMPERATURE | 104° F |
| Seal Minder® | Standard/Included |
