Summary: 316 Cast Stainless Steel Pumps with Shredder Action Impellers for Municipal, Industrial and Agricultural Waste-Water. Side discharge and non-clog single vane or double vane impellers for the passing of solids while delivering high volume of liquids. The Shredder (SKXF) pumps leave solids slightly larger than if passed through a grinder pump. The shredding action is caused by using a cutting impeller with a Tungsten Carbide Tip, against a "spiral" shaped diffuser plate. All wear and "wet" parts such as impeller, wear-plate, oil housing, pump-housing and inner pump top are made of Cast 316 stainless material. The elastomers such as o-rings, lip seals and gaskets are made of FMK.
-
All parts exposed to pumped liquidsare made of 316 Stainless Steel.
-
Elastomersare made of FMK.
-
Longer Power Cord - Standard 33ft. power cord.
-
Three Seal Motor Protection -Motor is protected by double mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic. An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber.
More Motor Protection - Winding protection and (NEMA) Class R motor insulation with a thermal cut out switch that will allow the stator to have a winding temperature of up to 300 degrees F (150C), superior to pumps with Class A and B insulation. Each pump is tested at factory, both for performance as well as safety. Level controls and level control systems are available.
Details:
GENERAL DATA | MAX. FLOW: GPM | 220 |
| MAX. HEAD: ft | 42' |
| PUMP TYPE | Non Clog Shredder Pump |
| DISCHARGE SIZE | 3" NPT-M |
| MAX. SUBMERGED DEPTH | 65' |
| SHIPPING WEIGHT:lbs | 95 |
CONSTRUCTION/MATERIAL DATA | MOTOR CASING | 316SS |
| PUMP VOLUTE | 316SS |
| STRAINER / STAND | 316SS |
| LIP SEALS & O-RINGS | FKM |
| ROTOR SHAFT | 316SS |
| EXTERNAL HARDWARE | 316SS |
| QTY. OIL IN SEAL CHAMBER | 10.1 U.S. FL. OZ., SHELL FM 32, NSF APPROVED |
| QTY. OIL IN MOTOR STATOR | 49 U.S. FL. OZ., OIL-FILLED W/ SHELL FM 32, NSF APPROVED |
ELECTRICAL/MOTOR DATA | MOTOR RATING: HP | 2 |
| MOTOR RPM | 3450 |
| MOTOR INSULATION CLASS | R |
| MOTOR SERVICE FACTOR | 1.1 |
| VOLTAGE | 230, 3PH-60Hz |
| CURRENT F.L.A. | 6 |
| MOTOR PROTECTION | Thermal Sensor Switches Embedded in Each Winding Phase |
| POWER CORD: GAGE; LENGTH | A.W.G. 16/4; 33', high temp. rated |
| MAXIMUM LIQUID TEMPERATURE | 200°F |
| Seal Minder® | STANDARD |
